ONTAP Hardware

iSCSI LUN size discrepancy in Windows 2019

THESALOPIAN
2,800 Views

I've got a spanned drive in a Windows 2019 server that consists of 6 iSCSI disks that were all meant to be the same size.  When I look in disk management Windows is reporting two of the disks to be 16349.35GB and the other 4 to be 16349.87GB in one view and all the same size when viewing the disks as part of the spanned drive. (I've attached a view from disk management to show this)

 

When I look in system manager or the command line they're all being shown as 15.97TB.   I'm getting problems with the two smaller disks reporting errors in Windows and I'm guessing it's down the the difference in size.   Does anyone know if it's possible to check the LUN size in GB rather than TB via an SSH  session to the storage cluster as I'm trying to nail down where the problem is. 

1 ACCEPTED SOLUTION

jcolonfzenpr
2,777 Views

you can use the set command to specified how the size is displayed.

 

set -units GB
set -units MB

[-units {auto|raw|B|KB|MB|GB|TB|PB}] - Data Units
Use this parameter to specify the default units used when reporting data sizes.

Possible values are:

 

  • auto - Auto-scale data size for human-readable output
  • raw - Bytes without unit designation
  • B - Bytes
  • KB - Kilobytes
  • MB - Megabytes
  • GB - Gigabytes
  • TB - Terabytes
  • PB - Petabytes

The default setting is auto.

 

https://docs.netapp.com/ontap-9/topic/com.netapp.doc.dot-cm-cmpr-930/set.html

 

Hope this help.

 

PD: For your specific problem try to check the lun size and lun & igroup ostype

 

Jonathan Colón | Blog | Linkedin

View solution in original post

2 REPLIES 2

jcolonfzenpr
2,778 Views

you can use the set command to specified how the size is displayed.

 

set -units GB
set -units MB

[-units {auto|raw|B|KB|MB|GB|TB|PB}] - Data Units
Use this parameter to specify the default units used when reporting data sizes.

Possible values are:

 

  • auto - Auto-scale data size for human-readable output
  • raw - Bytes without unit designation
  • B - Bytes
  • KB - Kilobytes
  • MB - Megabytes
  • GB - Gigabytes
  • TB - Terabytes
  • PB - Petabytes

The default setting is auto.

 

https://docs.netapp.com/ontap-9/topic/com.netapp.doc.dot-cm-cmpr-930/set.html

 

Hope this help.

 

PD: For your specific problem try to check the lun size and lun & igroup ostype

 

Jonathan Colón | Blog | Linkedin

THESALOPIAN
2,767 Views

Thanks, that's just what I was looking for.  I checked the size in Gb and they all looked the same size but when I changed the unit to MB then I could see that the two LUNS I have a problem with are 518 MB smaller.  I'm hopefully going to re-size the LUNS to match the others in the spanned windows drive.

 

Thanks for your help.

Public