Simulator Discussions

Configuring Cluster in OnTap 8.0.1 7-Mode.


I have two VM instances of Ontap 8.0.1 7_mode runningon VM workstation, can we go ahead and setup and setup clustering between them? Installed the license and rebooted but when i run cf enable or cf status i get the below error.

Both the VMs give the same error.

Netapp2> cf status
Netapp2 cluster monitor not initialized.
Partner is unknown
Netapp2> cf enable
cf: not initialized yet!


Re: Configuring Cluster in OnTap 8.0.1 7-Mode.

I dont think clustering is supported in the ontap 8 7 mode sim.

Cloud Volumes ONTAP
Review Banner
All Community Forums