Simulator Discussions

It is possible to install Simulate ONTAP on ESXI by using system setup tool

siddarajugc
3,266 Views

Hi All,

I am using System setup for testing purpose for installing Simulated ontap 8.3 on ESXi5.5.

 

It is possible to install simulate ontap on ESXI by using system setup?

 

please help me on urgent basis.

How to discover simlator by using IP ranges.

Thanks in advance.

 

 

Regards

Siddaraju

5 REPLIES 5

SeanHatfield
3,257 Views

it mostly works but out of the box it wont grab a DHCP address  instead go through node setup at the console to assign the mgmt ips then you should be able to go through discovery  

If this post resolved your issue, help others by selecting ACCEPT AS SOLUTION or adding a KUDO.

siddarajugc
3,252 Views

Hi sean,

 
 
 
 

SeanHatfield
3,215 Views

You need to boot regardless just to do the option 4, or the 44/4a.  But once booted 8.3+ goes into node setup, where it prompts for the mgmt port, ip, subnet, and gateway.  Then you can discover that address in system setup and use that tool to configure the simulator.

 

Another option would be to re-enable dhcp, in which case a lif called "mgmt_auto" will be created on the mgmt port and assigned a DHCP address.  But you still have to install ONTAP first.

 

 

 

If this post resolved your issue, help others by selecting ACCEPT AS SOLUTION or adding a KUDO.

aborzenkov
3,181 Views
How do we re enable DHCP before setup is complete?

SeanHatfield
3,179 Views

You'll see it in the loader if you printenv.  bootarg.init.dchp.disable=true.  set it to false.   bootarg.bsdportname sets the mgmt port.

 

 

If this post resolved your issue, help others by selecting ACCEPT AS SOLUTION or adding a KUDO.
Public