Software Development Kit (SDK) and API Discussions

Highlighted

fas8200 FC SAN fcp command failed

Hi,
Configuration is FAS8200 HA pair  NetApp Release 9.5P1, FC connected to Brocade 6510( HPE SN6000B 48 Port 16Gb Fibre Channel Switch ) FOS v7.4.1f
Commands "vserver fcp topology show" and "network fcp topology show" works fine but

"network fcp zone show" Fails:

Warning: Unable to list entries for kernel on node "node1": Fabric query operation timed out or was rejected.
         Unable to list entries for kernel on node "node2": Fabric query operation timed out or was rejected.
Error: show failed: Fabric query operation timed out or was rejected.
does this command relies on the brand of the SAN switch?
Regards,
Ben

6 REPLIES 6

Re: fas8200 FC SAN fcp command failed

According to the IMT FC -> ONTAP 9.5 ->  6510  show a min of 7.4.2b 

i would upgrade your switch if you can and start there.   

 

 

 

 

 

Re: fas8200 FC SAN fcp command failed

Thank you for your response.
I will try the newes version and let you know!
Regards,
Ben

Re: fas8200 FC SAN fcp command failed

OK the SANswitch firmware is updated to  Switch Release: v7.4.2d

But the error is the same:

network fcp zone show

show failed: Fabric query operation timed out or was rejected

The documentation does not help.

Maybe "zone show" depends on Metro cluster or zoneset-naming which are not used.

I think this command does not  applies to our configuration.

thank you for your support!

Regards,

Ben

Re: fas8200 FC SAN fcp command failed

That could be,  I don't see it listed in the MCC documentation.   

does "storage switch show" give you anything. 

Re: fas8200 FC SAN fcp command failed

The  result of the command "storage switch show"
This table is currently empty.

Re: fas8200 FC SAN fcp command failed

That's an MCC command.  https://docs.netapp.com/ontap-9/index.jsp?topic=%2Fcom.netapp.doc.dot-cm-cmpr-930%2Fstorage__switch__show.html

 

So yeah,  I'd agree that the ones you asked about  MCC only too. 

Forums