SolidFire and HCI

Bad Sectors on disk

Mohisina01
3,177 Views

We received quite few errors regarding the bad sectors on the disk.

 After raising a case we we informed to fail the disk manually and then replace

 

while trying to fail the disk, we are getting below error

 

storage disk fail -disk 2.10.3 -i true

 

Warning: The system will not prefail the disk and its contents will not be copied to a replacement disk before being failed
         out. Do you want to fail out the disk immediately? {y|n}: y

 

Error: command failed: Failed to fail the disk. Reason: Disk is not a file system disk.

 

 

Can anyone help,  

 

However all disk status are healthy  and are in green

 

 

1 ACCEPTED SOLUTION
4 REPLIES 4

Ontapforrum
3,158 Views

Is that (2.10.3) a spare disk (spare disk cannot be failed) ? You can run this command to check it -
::> storage disk show -spare

 

The "disk fail" command is used on a file system disk (data/parity).

Is that Storage a FAS/AFF (running ontap)?

Mohisina01
3,081 Views

yes it is a spare disk, so can we directly go and replace it without failing

Ontapforrum
3,080 Views

yes

MoS1
3,075 Views

It is preferred that we remove the drive from the cluster before replacing. Have you tried removing the drive via an API command or only through the GUI?

Public