Hello alltogether,
short question from us. We are using a Dynamic Disk Pool with 14 Drives. In the past we had 3 failures of hard disks. No problem ...read more
Hi expert
We found EF570 performance reduce 50% when one ssd fail.
Is it normal?
Our enviorment is 120 ssd, ssd size 3.2T, DDP pool, each pool 60 disk ...read more
run ./trident install -n trident error:
FATA Install failed; could not check if Trident installer pod is present; EOF. Resolve the issue; use 'trident ...read more
Hello, I'd like to share my experience with attempting to replace a contoller on an *old* 2600 series netapp, and see if anyone has other ideas or sug ...read more
Dear experts
What volume workload type should select for IBM SVC?
I have net app storage e2724. my it person lived the company and he not share any hand over.
i want to factory reset. but when i try connect via conso ...read more
Hi,I am new to this community and have recently began to build and optimize a storage array on an E-2860 for maximum data write throughput on large si ...read more
I have not the "Configure iSCSI Ports dialog box" on my netapp E2812. I can't configure iscsi on the controller.
What I should do to set up iscsi prot ...read more
We use four Linux servers, with SLES 11 SP4, in our backup environment. Two servers are connected via FC with two E2700s (FW 8.40.30.03). The two othe ...read more
I recieved a new NetApp E2812 and have used QuickConnect to do the inital configuration. I then connected it to our network and have tried to upgrade ...read more
