Hello!
Models FAS2240, FAS2552, FAS2750, which consist of two nodes (7-Mode or Cluster mode), have two power supplies.I have each power supply connect ...read more
Hi All,
Hello All,
Need a bit of help, we are planning to convert switch-less cluster (Ontap 9.5P10) to switched cluster, so customer buy couple ...read more
Good afternoon!I have NetApp 2750 ONTAP 9.7 Cluster mode (two HA nodes: netapp03-01 and netapp03-02)When running the command "system node reboot -node ...read more
Hi,I'm new here in the community.I don't know if the connection between the FAS / V3140 and a DS4243 is correct. Can someone help me?
Here are the pic ...read more
Dear all,
I am newbe in netapp. We have an FAS2020/DS14Mk2 with Ontap 7.3.1.1. We shut it down 3 years ago, then running with esxi 6.0. For a small pr ...read more
Dear All,
I have a new FAS2750 HA system that is being configured. However, I just realized that the adapter is CNA with four FC SFPs per controller.T ...read more
Good afternoon!I have NetApp FAS2552 ONTAP 9.1 Cluster HA (two nodes).In the Network Interfaces settings I can see that the data interface lif for cif ...read more
Hello,
I have a two node system that we have to power off for a few hours this Saturday. It is aFAS2750 with one disk shelf. We are running ONTAP 9.7. ...read more
Hi Guys,
is it possible for testing purposes to switch a A220 to a ASA220? Or is in ASA220 different Hardware included?
Thanks for feedback
- Products and Services
- General Discussion & Community Support
- Developer Network
- NetApp Learning Services
- Blogs
- Tech ONTAP Newsletter
