What version of PS are you running and what version of toolkit version and Ontap I'm running PS 3 Toolkit version: 3.3.0.65 ontap 8.3.1GA
... View more
Just a question to the community,
If we are mounting hard mounts with intr and we have a vfiler and then activate a vfiler DR- do all the clients have to unmount and remount nfs? ANd if so, why? The ip is different from Prod and DR? But, the NFS clients are mounting FQDN
... View more
Is this for a DR test or a real DR You are looking to flip over and run in alternative site and them flip back? Also, you have to make sure that unless you are using some form of SVM-DR in 8.3.1, all resources will have to get recreated in DR, either via manual or script (shares,exports, junctions, etc)
... View more
Yes, you can figure out pretty easily which volume is producing the most ops and go from there. priv set adv stats show -n 50 -i 1 volume:*:total_ops Also, high CPU doesn't always mean a bad thing.. check it out with sysstat -M 1
... View more
your partner statement is incorrect, you need to add vlan. ifconfig agg0-111 192.168.111.250 netmask 255.255.255.0 mtusize 1500 partner agg1-111 try that Also, you are on some VERY old hardware and code.. time to upgrade
... View more
If I understand you correctly, you are trying to use a TDP relationship to peer a snapvault secondary to cDOT. Unless something has changed, I don't beleive that is supported. Check the message file
... View more
Whomever ordered the systems ordered them wrong. They should have been ordered with 7-mode SKU and not cDOT sku. But, since it's a new system, just call support and they will walk you thru
... View more
Not to be rude, but it sounds like you need to understand the basic fundamental commands. Please try to take the web training classes that will help you out. I will get you started on this one.. assuming this is 7-mode as in your tag, you can look - vol status (look for guarantee) But please review some web based training
... View more
Two scenarios, OCUM 6.3 for cDOT and 7-mode First, 7-mode, is there a way to setup user quota alerts in DFM, where DFM pulls the mail attribute directly from Active Directory, or the way it works in 7-mode, you have to manually entire each users email address? For cDOT, same question as above, with OCUM 6.3, can we setup AD to pull mail attribute so when it sees user based quotas, it can email user directly? Thanks
... View more
