Hi , Are you sure that lun show -m and lun show -v can give the lun used space on the storage side . lun show -m ----- lun mapping details to igroup lun show -v -- detailed status of lun can get some estimated used information using the "df -g volume name" if only one lun is provisioned on that volume . Thanks Ashwani
... View more
Hi , I have a problem with filer access .I am able to ssh the filer from cli console but when trying to run any ontap commands( df -g , vol status etc ) its giving permission denied error Please help Regards Ashwani
... View more
Hi , I have also ecountered these type of permission problem when acl list for particular folders got some garbage values and actual were deleted .So we configured the acl list manually .Didnt figure out the reason till now ,but need to navigate through windows side .
... View more
Hi , Sorry for not asking the below things 1st time . Please also provide the ">vol option volume_name " output & details of other lun if any in this volume Thanks Ashwani
... View more
Hi , One thing I missed that is your source volume has fractional reserve set to 100 .Please check if that is set to 100 then its fine to have on destination volume . Yes fractional reserve is different then snap reserve . Fractional reserve is used in SAN volumes to ensure space reservation for lun
... View more
Hi Anuj , The fractional reserve is 100 ? please remove this . Restrict the volume once again .Ensure the size of destination volume is => source volume .Run the > snapmirror initialize -S srcvolume destinationfiler:destinationvolume
... View more
Hi Nayab , See the snapvault volume has fractional reserve set to 100 . No need of this reserve remove it and then start vaulting your primary qtree's to this destination .Hope this will resolve your issue . thanks Ashwin
... View more
Hi Anuj , Check last two things 1) if snapmirror is licensed on destination . 2) if you are able to ping destination filer ip from the source .
... View more
Hi Anuj , Try to edit the conf file as smoke6-vsim-pbc7b6g:vol3 smoke6-vsim-pbc7b6h:vol3 - * * * * * Then run initialize command thanks Ashwani
... View more
I think we missed something if the vfiler has been removed from AD we cannot connect it to using Windows MMC . I think you have to re - run the Cifs setup add the vfiler to domain ,close your open files connecting vfiler from Windows MMC ,cifs terminate ,exclude the vfiler from domain .
... View more
Hi , Can you please provide the status of the volume which holding this lun like volume current usage (df -g ) , vol status ,vol options and if that volume is also holding any other lun ? Thanks , Ashwani
... View more
Copy speed will depend on source and destination distance . Yes you can do it minimum outage . 1) Start with ndmpcopy 0 level 2) Once your data is copied using level 0 ndmpcopy use ndmpcopy level 1 & level 2 (if required) for incremental data written when level 0 was running . Use level 1 & level 2 copy at the time when there is no or minimum data being written on lun . After level 2 i hope the new lun has all the data of old lun and then mount the new lun on server
... View more