Re: FAS2220 iSCSI - No LUNs showing up in Windows 2008

SEVENTH777 · ‎2013-02-14

Hello,

I have a FAS2220 that I've just enabled/licensed iSCSI on. I'm trying to connect to three LUNs that I've created in OnCommand. I can discover the iSCSI target by IP address in the Windows iSCSI Initiator, but when I go to Volumes and Devices, I do not see any of the LUNs available so that I can mount them.

In OnCommand, I created 3 LUNs, and set the permissions to allow any connections. I then added the Initiator Name that was generated by Windows.

Unfortunately OnCommand is now hanging on me, so I can't really get into any more detail than that. The windows initiator is (as best I can tell) is allowed to connect, the target comes up, the LUNs are online, but nothing shows up under Volumes and Devices in Windows (2008 Server R2).

Any insight would very much be appreciated. Thanks!

SEVENTH777 · ‎2013-02-14

Also - is there a way to skip the dashboard when I login via OnCommand? I can't get the tool to respond at all now, the script just times out.

radek_kubka · ‎2013-02-15

Hi Chris and welcome to the Community!

How about jumping into the command line?

Can you post the outputs of:

igroup show

lun show -m

Regards,

Radek

SEVENTH777 · ‎2013-02-15

Certainly I have a FAS2020 as well (as well as a V3210) and I'm having the same issue with all of them. I'm sure I'm just missing a step, but here's the output of those commands:

fas2220> igroup show

HBSS (iSCSI) (ostype: windows):

iqn.1991-05.com.microsoft (not logged in)

iqn.1991-05.com.microsoft:winslq3r2tam1v (not logged in)

fas2220> lun show -m

LUN path Mapped to LUN ID Protocol

-----------------------------------------------------------------------

/vol/hbss2_vol/hbss2 HBSS 0 iSCSI

/vol/hbss3_vol/hbss3 HBSS 2 iSCSI

/vol/hbss_vol/hbss1 HBSS 1 iSCSI

radek_kubka · ‎2013-02-18

LUNs are mapped (2nd output), but your initiator is not logged in (1st output).

Did you try logging in into iSCSI portal via host iSCSI GUI interface?