Hello, we're running DFM version 4.0.2 and using protection manager to backup our Netapps. I'm looking for a policy that provides a local backup, then backup primary to secondary, and also backup primary to another secondary. I have a backup Netapp local to the primary Netapp and also another backup Netapp at another site I would just like to use to keep a fail safe backup. I was not interested in using the DR mirror for the offsite Netapp for a few reasons. Is there a way to accomplish this? Create a new policy not reliant on the examples given?
FIrst of all, pls upgrade to 5.0.2P1 or later, as its the current GA release and also true 64bit application. 4.0.2 is already End of Support with the release of OCUm 5.2.
I would also recommend you to move to 5.2 as soon as possible.
Now coming to your question. Using PM you cannot create policy topology of your own other than the predefined one. In fact we do have a policy which does the following, similar to what you are looking for except that the second backup is VSM or QSM.
Backup And Mirror
Or Mirror to 2 destination
Alternatively you can achieve what you are looking for by using the simple backup policy twice on the same source with 2 set of destination. You will end up creating 2 dataset for the same primary with Backup policy and different destination volume.
Also in one of the dataset with backup policy make the local backup schedule to none so that you don't have twice the number of snapshot being taken and retained in the primary.
So you will have 2 set of backup destination for the same primary but in 2 datasets instead of 1 due to the policy topology restrictions.
Thanks so much for your answer. It did cross my mind to have two datasets for the same primary but wasn't sure if that was possible or recommended. You've cleared that up.
In regards to the upgrade, I would definitely like to upgrade if it supports my environment with no additional licensing purchases. We currently use DFM for monitoring and protection manager for over 20 Netapps. I was under the impression OnCommand would only work for Netapps running OnTap 8.X.X? We have a number of Netapps ranging from FAS270, FAS3020, FAS3040, FAS2050, and FAS2040 all running 7.3.X. Some of them would not support Ontap 8. I tried looking for this information online but did not have any luck
Re: Looking for an alternate DFM protection policy example