Active IQ and AutoSupport Discussions

Refresh My Autosupport

ndanny
8,009 Views

Is there a way to refresh the configuration after you mitigate a risk?  Do I need to initiate an AutoSupport from the filer?

1 ACCEPTED SOLUTION

ndanny
8,009 Views

I was able to resolve this by "tricking" the My AutoSupport update.  I sent a "Weekly Log" update using the following command.

options autosupport.doit WEEKLY_LOG

View solution in original post

3 REPLIES 3

ndanny
8,010 Views

I was able to resolve this by "tricking" the My AutoSupport update.  I sent a "Weekly Log" update using the following command.

options autosupport.doit WEEKLY_LOG

NICOLAS_MELAY
8,009 Views

This will still send autosupport alerts to .to and .noteto recipients.

Wish there was a way to simulate the weekly NetApp-only autosupport, and nothing more.

andris
8,009 Views

Well, if you're running 8.0 or 8.1 Data ONTAP, you can temporarily disable the ASUP message for  USER_TRIGGERED to your .to and .noteto recipients.

Invoke your fake USER_TRIGGERED (WEEKLY_LOG). Then reinstate your .to and .noteto destinations.

For 8.0 instructions, see KB: 1913810

https://kb.netapp.com/support/index?page=content&id=1013810

In 8.1, use the "autosupport trigger modify" command for the "invoke.all" event.

Public