Active IQ and AutoSupport Discussions

change autosupport payload to tgz

buim
4,086 Views

Hi All,

I need to change the asup payload format to tgz but can't see the options available in CDOT 8.2.2RC2

This is the command used and it's the same listed in the tech doc.

error:

*> system node autosupport modify -node local -payload-format tgz

Error: invalid argument "-payload-format"

The is the tech doc.

https://kb.netapp.com/support/index?page=content&id=3013763

AutoSupport has a new diagnostic level configuration setting that allows the user to change the payload format. The available options are either 7z or tgz:

  • Clustered ONTAP

filer::> system node autosupport*> modify -node local -payload-format 7z  
filer::> system node autosupport*> show -node local -fields payload-format

Any suggestions?

1 ACCEPTED SOLUTION

aborzenkov
4,086 Views

Are you in diagnostic mode?

View solution in original post

2 REPLIES 2

aborzenkov
4,087 Views

Are you in diagnostic mode?

buim
4,086 Views

No, I was not in diag mode.

change to diag mode and able to change the payload-format. 

thx..

Public