Trying to reload firmware on an Onkyo receiver and getting an error

[tibimakai]

New here, hello to everybody. I'm a newby, with this stuff as well.

I'm just trying to repair an Onkyo home theater receiver, that had a bad microcontroller. Software is gone, I can't get it out of it.

Replaced the microcontroller and I'm trying to reload the firmware on the board, but I'm getting an error and I'm hoping to get some answer, from you fine folks. What could be the problem here?

Any help would be greatly appreciated.

This is what I get from Putty:

(Error is at the bottom)

I have attached the log, because it is to long.

[AlexDawson · Accepted solution]

Hi there!

This is the product support forum for NetApp's products, and while we've had some diversity in our products over the years, that hasn't extended to home theater products.

I suspect you'll have more luck at https://www.avsforum.com/

Thanks!