Get-NaEfficiency (TotalLunSize and OverProvisioningPercent) commands aren't working properly

[tsener]

Hi all ,

Get-NaEfficiency   (TotalLunSize and OverProvisioningPercent) commands aren't working properly

vol1 : 100g (thin)

vol2 : 100g (thick)

lun1 : /vol/vol1/lun1    , 150g(thin)

lun2 : /vol/vol2/lun1    , 50g(thick)

(Get-NaEfficiency vol1).TotalLunSize  is "0"

(Get-NaEfficiency vol1).OverProvisioningPercent is  "0"

(Get-NaEfficiency vol2).TotalLunSize  is "0"

(Get-NaEfficiency vol2).OverProvisioningPercent is  "0"

 TotalLunSize:  Total size of all the LUNs contained within this volume.  This value is only valid when the -Recurse switch is present.

 OverProvisioningPercent: The LUN over-provisioning percent of the volume.  This value is equal to (TotalLunSize / Capacity) * 100.  This value is only valid when the -Recurse switch is present.

But it must be different value.

do you have any idea ?

[asulliva · Accepted solution]

You'll need to use the "-Recurse" switch for those values to be populated:

(Get-NaEfficiency vol1 -Recurse).TotalLunSize
(Get-NaEfficiency vol2 -Recurse).TotalLunSize

Andrew

[tsener]

Thank you asulliva