One of the disks failed which was part of the ADP's partition on an aggregate.
The partition got replaced, but we never saw hot spare in the system at all. After replacing the disk we see the disk as a hot spare and it did not get partitioned.
Now should I manually partition the disk so that it can go to the spare partition ? or leave it in case of a failure the disk will be pulled in and a partition will be created later on ?
Before failure
RAID Disk Device HA SHELF BAY CHAN Pool Type RPM Used (MB/blks) Phys (MB/blks)
--------- ------ ------------- ---- ---- ---- ----- -------------- --------------
Spare disks for block checksum
spare 0a.10.7P3 0a 10 7 SA:B 0 SSD N/A 11284/23110656 11292/23127040 (fast zeroed)
spare 0a.10.8P3 0a 10 8 SA:B 0 SSD N/A 11284/23110656 11292/23127040 (fast zeroed)
spare 0b.00.23P1 0b 0 23 SA:A 0 SSD N/A 1825625/3738881024 1825633/3738897408 (fast zeroed)
After Failure
RAID Disk Device HA SHELF BAY CHAN Pool Type RPM Used (MB/blks) Phys (MB/blks)
--------- ------ ------------- ---- ---- ---- ----- -------------- --------------
Spare disks for block checksum
spare 0a.10.7P3 0a 10 7 SA:B 0 SSD N/A 11284/23110656 11292/23127040 (fast zeroed)
spare 0a.10.8P3 0a 10 8 SA:B 0 SSD N/A 11284/23110656 11292/23127040 (fast zeroed)
Broken disks
RAID Disk Device HA SHELF BAY CHAN Pool Type RPM Used (MB/blks) Phys (MB/blks)
--------- ------ ------------- ---- ---- ---- ----- -------------- --------------
failed 0a.00.18P1 0a 0 18 SA:B 0 SSD N/A 1825625/3738881024 1825633/3738897408 (fast zeroed)
After replacing the Disk
RAID Disk Device HA SHELF BAY CHAN Pool Type RPM Used (MB/blks) Phys (MB/blks)
--------- ------ ------------- ---- ---- ---- ----- -------------- --------------
Spare disks for block checksum
spare 0a.10.17P3 0a 10 17 SA:A 0 SSD N/A 11284/23110656 11292/23127040 (fast zeroed)
spare 0b.00.18 0b 0 18 SA:B 0 SSD N/A 3662580/7500964352 3662830/7501476528