Hello,
I have a Netapp FAS2240-4 with Release 8.2.4P4 7-Mode. It has two controller boards, one disk shelf an a total of 48 disk (24x2TB in the FAS and 24x1TB in the shelf). It is out of support, so I think I can not upgrade Ontap. I used to have the disks configured like this:
Now I would like to use a configuration like this:
I bootet into maintenance mode and changed the owner of all disks to Node 1. But now Node 2 does not boot, because it does not have any disks. The status of the aggregates is like this:
aggr status -v
Aggr State Status Options
aggr0 online raid_dp, aggr root, diskroot, nosnap=off, raidtype=raid_dp,
64-bit raidsize=11, ignore_inconsistent=off,
snapmirrored=off, resyncsnaptime=60,
fs_size_fixed=off, lost_write_protect=on,
ha_policy=cfo, hybrid_enabled=off,
percent_snapshot_space=0%,
free_space_realloc=off
Volumes: vol0
Plex /aggr0/plex0: online, normal, active
RAID group /aggr0/plex0/rg0: normal, block checksums
RAID group /aggr0/plex0/rg1: normal, block checksums
aggr1 offline raid_dp, aggr diskroot, raidtype=raid_dp, raidsize=11,
foreign resyncsnaptime=60, lost_write_protect=off,
64-bit ha_policy=cfo, hybrid_enabled=off,
percent_snapshot_space=0%
Volumes: <none>
Plex /aggr1/plex0: online, normal, active
RAID group /aggr1/plex0/rg0: normal, block checksums
RAID group /aggr1/plex0/rg1: normal, block checksums
And the volume:
vol status -v
Volume State Status Options
vol0 online raid_dp, flex root, diskroot, nosnap=off, nosnapdir=off,
64-bit minra=off, no_atime_update=off, nvfail=off,
ignore_inconsistent=off, snapmirrored=off,
create_ucode=on, convert_ucode=on,
maxdirsize=45875, schedsnapname=ordinal,
fs_size_fixed=off, guarantee=volume,
svo_enable=off, svo_checksum=off,
svo_allow_rman=off, svo_reject_errors=off,
no_i2p=off, fractional_reserve=100, extent=off,
try_first=volume_grow, read_realloc=off,
snapshot_clone_dependency=off,
dlog_hole_reserve=off, nbu_archival_snap=off
Volume UUID: 370ddab1-6719-11e3-8d9a-123478563412
Containing aggregate: 'aggr0'
Plex /aggr0/plex0: online, normal, active
RAID group /aggr0/plex0/rg0: normal, block checksums
RAID group /aggr0/plex0/rg1: normal, block checksums
Snapshot autodelete settings for vol0:
state=off
commitment=try
trigger=volume
target_free_space=20%
delete_order=oldest_first
defer_delete=user_created
prefix=(not specified)
destroy_list=none
Volume autosize settings:
mode=off
Hybrid Cache:
What steps am I missing to setup the configuration in the picture above? If possible, I do not want to start from scratch.
Thank you,
Andreas
Eligibility=read-write
