Solved: Re: Command to get aggregate subscription details

Ashish_Sharma · ‎2017-08-09

Is there a way/command to get aggregate subscription details via *CLI* on Cluster ONTAP 8.3 and later?

colsen · ‎2017-08-09

Hello,

Are you asking about the level of commitment of the aggregate (i.e. how much thin-provisioning was done against the aggregate)? I found some older threads where knowledgable NetApp folks essentially said "nope, no way to display committed percent via the CLI". However, if you're using OCSM, you can click on the volumes tab of the aggregate information page and it shows it there.

OCUM displays the information as well.

Hope that helps,

Chris

View solution in original post

colsen · ‎2017-08-09

Hello,

Are you asking about the level of commitment of the aggregate (i.e. how much thin-provisioning was done against the aggregate)? I found some older threads where knowledgable NetApp folks essentially said "nope, no way to display committed percent via the CLI". However, if you're using OCSM, you can click on the volumes tab of the aggregate information page and it shows it there.

OCUM displays the information as well.

Hope that helps,

Chris

Ashish_Sharma · ‎2017-08-13

Hi Chris,

Thank you for your response.

Yes, this post was in regards to level of commitment of the aggregate.

I do have that information on OCUM GUI. But I want that info on CLI which is not possible at this time.

Thank you.