ONTAP Discussions

Error Configuring FC-to-SAS bridges for health monitoring

Mutua
4,580 Views

Hello.

 

I have launched the "storage bridge -address aaa.aaa.aaa.aaa" command on a FAS8040 MetroCluster set in, following the recommendation of KB ID 1015166 and get the following message: "Bridge is not reachable over SNMP on node "NODE1" in cluster "CLUSTER". Verify the management node is lif up by using the command "show network interface" Then try the command again. "

 

When I launched the "add -switch-storage switch ipaddress" command to the IP of the FC switches BROCADE been executed correctly.

 

MetroCluster is formed by two FAS8040 Data ONTAP 8.3.2, four FC switches BROCADE 6505 with version 7.4.0a and four ATTO FibreBridge 6500N with firmware 1.61

 

The four bridges respond to ping from the four nodes of MetroCluster

 

SNMP configuration is by default in the MetroCluster and bridges.

 

Any suggestions?

 

Thanks

 

 

1 ACCEPTED SOLUTION
2 REPLIES 2

andre_koch
4,072 Views

Hi

 

do you find a solution. I have exactly the same issue, but with ONTAP9.1

Public