ONTAP Discussions

Failed Disk Registry information ?

Beardmann
5,934 Views

Hi there

 

I often use the Failed Disk Registry when replacing disks on a NetApp system, and I simple unpack the .7z file which is emailed via the autosupport feature.

If you unpack the attached file, you will find a file called "FAILED-DISK-REGISTRY.txt" which contains all the failed disks in the controllers lifetime.

 

I think that in the earlier 6.x versions this information was avaliable from the commandline, either via a command, or by reading a file with rdfile in /vol0/etc/...

 

But I have been looking for both a command and a file in /etc/ and cannot find it...  does anyone know if it is possible to get this information on 7-mode/cDot systems ?

 

Kind regards,

Heino

3 REPLIES 3

aborzenkov
5,827 Views

FDR information is available using diag level commands. As usual, you are advised to contact support if you want to use them.

pawan_goswami27
5,031 Views

Hi Please,

 

Provide command to check FDR in diag mode.

nwvs6095131
3,979 Views

found the command - you have to do it in set diag priveledge mode -  system node run -node * -command raid_config info showfdr

Public