ONTAP Discussions

How to identify a node by using commands

netappmagic
views-count 1096 Views

I am trying to physically identify a node within a HA, are there any commands? I am not sure which one is which in the canbinet in Data Center. Thanks for your inputs!

2 REPLIES 2

Re: How to identify a node by using commands

naveens17
views-count 1097 Views

run 

 

system controller show // get the serial number and check 

Re: How to identify a node by using commands

schmitz_peter
views-count 1097 Views

@netappmagic wrote:

I am trying to physically identify a node within a HA, are there any commands? I am not sure which one is which in the canbinet in Data Center. Thanks for your inputs!


I assume you are using CDOT.

 

Try "system controller location-led show", or "system controller location-led modify on"

 

Manpage is "man system controller location-led modify"

 

Though, I don't know which controllers actually support this command.

 

Cheers

 

Peter

G2 Review Banner
All Community Forums
Public