ONTAP Discussions
ONTAP Discussions
hello everyone
we have two sides with fabric attached metrocluster and we have 2 dark fiber links between them both links physically up but when we run ic status command we get:
ic status
Link 0: down
Link 1: up
cfo_rv connection state : CONNECTED
cfo_rv nic used : 1
cfo_rv2 connection state : CONNECTED
cfo_rv2 nic used : 1
when i run sysconfig -a command :,
slot 1: FCVI Host Adapter 1a (QLogic 2532(2562) rev. 2, F-port, <DOWN>)
Physical link: UP
FC Node Name: 21:00:00:24:ff:3f:b3:8e
Firmware rev: 5.3.140 Serial No: RFD1217B08814
Host Port Id: 0x20500
Cacheline size: 8 FC Packet size: 2048
SFP Vendor: JDSU
SFP Part Number: PLRXPLVCSH423NQL
SFP Serial Number: CB51ED3G0
SFP Capabilities: 2, 4 or 8 Gbit
Link Data Rate: 4 Gbit
Switch Port: FQMCSW2:5
I/O base 0x00000000ffffff00, size 0x100
memory mapped I/O base 0xdec00000, size 0x4000
slot 1: FCVI Host Adapter 1b (QLogic 2532(2562) rev. 2, F-port, <UP>)
Physical link: UP
FC Node Name: 21:00:00:24:ff:3f:b3:8f
Firmware rev: 5.3.140 Serial No: RFD1217B08814
Host Port Id: 0x10500
Cacheline size: 8 FC Packet size: 2048
SFP Vendor: JDSU
SFP Part Number: PLRXPLVCSH423NQL
SFP Serial Number: CB51ED3G4
SFP Capabilities: 2, 4 or 8 Gbit
Link Data Rate: 4 Gbit
Switch Port: FQMCSW1:5
I/O base 0x00000000ffffff00, size 0x100
memory mapped I/O base 0xdec04000, size 0x4000
my question link is up and port is down this normal or not and what the solution.
regards.
Hello,
i have the same issue by a customer.
Found you an solution ?
Best Regards
Jan Janssen
my question link is up and port is down,Found you an solution ?
the link between the adapter 1a and switch FQMCSW2 port 5 is down. Most likely a SFP is dead.
Usually replacing sfp - cable - sfp should address it.
you can also use sfpshow 5 on the switch to get more details on whats going wrong and get sensor readings.
And you definitely should upgrade Ontap to 8.2.
ak.