Moving snapvault destination volume to another aggregate

[GUVNIJJAR]

I am using ontap v7, and am looking to move a volume from aggregare to another aggregate on the same filer.  This volume is also a snapvault destination and also setup as a share.  The snapvault source is on another filer.  So i guess moving a volume from one aggregate to another we can use snapmirror.  But what do we need to do the snapvault relationshiop to continue the sync, as i dont want to basline the relationship again.  Any ideas on steps on doing this move including the snapvault work

[brauntvr2swiss]

Hi

You can doit like its descripted under Following link on Site 110:

https://library.netapp.com/ecm/ecm_download_file/ECMM1278858

Short Version:

- snapmirror start

- snapmirror quiesce

- snapmirror break

- snapvault start -S (with the new Volume)

--> Following Message occurs

     Snapvault configuration for the qtree has been set.

     Qtree /vol/new_vol/bno_C_500MB is already a replica.

- snapvault update

regards

Thomas

[PoehlmannU]

Good documentation, thank you!

I successfully moved my old snapvault destination volume using snapmirror to another volume, is it possible to move the existing snapvault_snapshots from the old volume as well? I run a backup filer and want to keep the existing daily snapvault_snapshots in the new volume.

Is this possible?

[PoehlmannU]

Solved myself, RTFM

Volume Snapmirror 🙂

[arunchak]

Do you use DFM? IF so you can use the secondary space management wizard to migrate the destination volume to another aggr. It would preserve your relationship.