Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Mute
- Printer Friendly Page
Netapp Metrocluster Tiebreaker, cluster add wizard failure
2016-06-21
05:23 AM
5,008 Views
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi
Im using TB software version 1.1-1.x86_64. Installation is OK but adding cDot cluster fail with error ZAPI execution failed on cluster - x.x.x.x Reason unknown.
there is separare user with admin priviledges and ssh, ontapi and http allowed. Does the user need some more rights or what can be reason?
Network setup is quite complicated but in another hand other softwares like OCUMs works fine from same segment, so my first suspicion is not on network related issues.
4 REPLIES 4
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
there is a lot of reasons for this. Can you please open a support case and send me the Case #?
Thx,
Andy
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello!
I have the same issue after upgrade cDOT MetroCluster system from 8.3.x to 9.1.
Did you solve this issue?
Thank you!
Klemen Bregar
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Are you using Tiebreaker 1.2? Can you please ensure that the system has https as well as ssh access to the cluster?
Andy
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi, problem was with HTTP in TB 1.1 didn't support HTTPS, TB 1.2 fix issue. Just make sure you have enough rights on controller for your TB user, HTTPS and SSH connections working to nodes and cluster management IPs.