ONTAP Discussions

Netapp storage show command "Phy State" which shows in slot 0c

1VINAYKUMAR
3,714 Views

Hi Guys,

 

Just want to know about the "Phy State" which shows in slot 0c. can anyone help me to know about it.

 

netapp01> storage show adapter
 
Slot:            0a
Description:     Fibre Channel Host Adapter 0a (QLogic 2432 rev. 2)
Firmware Rev:    4.4.0
FC Node Name:    9:00a:098088:25dxyz
FC Packet Size:  2048
Link Data Rate:  4 Gbit
SRAM Parity:     Yes
External GBIC:   No
State:           Disabled
In Use:          No
Redundant:       Yes
 
Slot:            0b
Description:     Fibre Channel Host Adapter 0b (QLogic 2432 rev. 2)
Firmware Rev:    4.4.0
FC Node Name:    9:00a:098188:25dxyz
FC Packet Size:  2048
Link Data Rate:  4 Gbit
SRAM Parity:     Yes
External GBIC:   No
State:           Disabled
In Use:          No
Redundant:       Yes
 
Slot:            0c
Description:     SAS Host Adapter 0c (LSI Logic 1068E rev. B2)
Firmware Rev:    1.26.03.00
Base WWN:        a:060xyz:2000888:00
State:           Enabled
In Use:          Yes
Redundant:       No
Phy State:       [0] Enabled, 3.0Gb/s (9)
                 [1] Enabled, 3.0Gb/s (9)
                 [2] Enabled, 3.0Gb/s (9)
                 [3] Enabled, 3.0Gb/s (9)
Slot:            0e
Description:     IDE Host Adapter 0e
netapp01>

 

regards

VK

3 REPLIES 3

YIshikawa
3,694 Views

PHY State shows state of SAS PHY layer.

 

https://en.m.wikipedia.org/wiki/Serial_attached_SCSI

 

Your output shows that port 0c has 4 links and each link is up in 3Gbps.

1VINAYKUMAR
3,680 Views

 

Thanks YIshikawa for your quick response, can you help me out to understand clearly, how these links are connected or used in NetApp environment.

 

regards

VK

YIshikawa
3,656 Views

This port is cabled with some port of disk shelf module. Single cable has 4 PHY links, so you can see only one cable on port 0c but this cable has 4 links(lanes) inside.

Public