Hi - I am staging a new Netapp 3270 with Chelsio Dual 10gig nic connected to an HP 5406zl - but after upgrading from 7.3.5.1P1 to 7.3.5.1P2 and rebooting I am getting no link on any of the 4 ports on the 5406zl side.
(I'm not sure the upgrade was the culprit, but its one of the last changes before the link on all 4 went down) - previously we had link
When I bring up the nic with ifconfig e1a up, the status changes to auto-unknown-enabling for a few seconds, then auto-unknown-down)
Netapp:
na04> sysconfig -v 1
slot 1: Dual 10G Ethernet Controller T320E-SFP+
Device Type: CT-31-3
Version Number: T3-SRAM1.1.0-BR1114-30-A0-FW7.7.2-DR04
Serial Number: PT12110481
e1a MAC Address: 02:a0:98:99:50:ea (auto-unknown-down)
e1b MAC Address: 02:a0:98:99:50:ea (auto-unknown-down)
5406zl:
> sho int brief c3,c4
Status and Counters - Port Status
| Intrusion MDI Flow Bcast
Port Type | Alert Enabled Status Mode Mode Ctrl Limit
------ --------- + --------- ------- ------ ---------- ----- ----- ------
C3 SFP+SR | No Yes Down 10GigFD off 0
C4 SFP+SR | No Yes Down 10GigFD off 0
Should I try swapping out the tranceivers?
The weird thing is I was getting link earlier in the day and the switch was logging up and down entries when I was bringing netapp vifs up and down during testing - but now nothing - the link is stuck DOWN on the 5406zl.
Anyone seen this after going to P2?
We've tried disabling/enabling, reseating fiber connections - still no LINK.
Thanks for any tips!
http://vmadmin.info
Fletcher.
