Solved: Re: Ontap 9 select crash after upgrade to esxi 6.5

stephenyu · ‎2017-02-09

How can I fix this issue?

stephenyu · ‎2017-02-10

thanks a lot

I added floppy drive in VM.

Netapp can boot up

SeanHatfield · ‎2017-02-09

Was the VM hardware version upgraded? This same behaviour will occur starting around vm hardware version 11.

If this post resolved your issue, help others by selecting ACCEPT AS SOLUTION or adding a KUDO.

stephenyu · ‎2017-02-10

I did not upgrade hardware. Any solution I can power on back netapp

SeanHatfield · ‎2017-02-10

From the loader prompt run this command and post the output:

lsdev

If this post resolved your issue, help others by selecting ACCEPT AS SOLUTION or adding a KUDO.

stephenyu · ‎2017-02-10

SeanHatfield · ‎2017-02-10

Drive A is missing. Add a floppy drive to the VM, and connect a blank floppy image. Then see if it will come up.

The fat16 volume is expected to be on disk1s2.

If this post resolved your issue, help others by selecting ACCEPT AS SOLUTION or adding a KUDO.

stephenyu · ‎2017-02-10

thanks a lot

I added floppy drive in VM.

Netapp can boot up

stephenyu · ‎2017-02-10

I did not upgrade hardware. Any solution I can power on back netapp