Hi Guys,
Thanks for the reply, when i run the Snapmirror show command on cluster. it shows the below output and its a bit difficult to understand or if the snapmirror configuration is on SVM or volumes.
SourceLocation DestinationLocation Status MirrorState LagTime RelationshipType
-------------- ------------------- ------ ----------- ------- ----------------
PEPNS00044-PI: PEPNS00044-DR: idle snapmirrored 00:04:47 data_protection
PEPNS00044-PI:vl_VMdata PEPNS00044-DR:vc_VMdata idle snapmirrored 00:04:45 data_protection
PEPNS00044-PI:vl_home PEPNS00044-DR:vc_home idle snapmirrored 00:04:45 data_protection
PEPNS00044-PI:vl_rdshome PEPNS00044-DR:vc_rdshome idle snapmirrored 00:04:45 data_protection
PEPNS00044-PI:vl_rdsprofiles PEPNS00044-DR:vc_rdsprofiles idle snapmirrored 00:04:45 data_protection
the above output shows the SVM as well as the SVM:Volname, whereas as for as i understand it should be only SVM: but not with the volumes, if configured for SVM DR. a bit confusing for me to understand the Snapmirror configuration.
regards
VK