ONTAP Discussions

Unable to Mount volume created in SVM to XenCenter SR

shoong
4,419 Views

Hi,

 

I have a FAS2552/XenServer combo running in my environment. I currently do have 1 SVM created and have volumes attached as Xen's SR. 

 

I created a second network interface under the same subnet but different IP, created a new SVM, copied the policies over and I'm unable to mount it. The error just states, there was an error and to check my settings. From the XenServer itself I can ping the IP that was assigned to the new Network Interface on the NetApp.

6 REPLIES 6

AlexDawson
4,394 Views

Hi there,

 

Depending on how you created the SVM, check that the NFS or iSCSI service is running for that SVM - each SVM needs it setup or turned on and by default it may not be.

 

Hope this helps!

shoong
4,392 Views

Hi Alan,

 

The NFS service is turned on.

AlexDawson
4,388 Views

Can you run showmount and rpcinfo against the old and new IPs from your client system?

 

We have this troubleshooting document that may help - https://kb.netapp.com/support/s/article/ka31A000000148aQAA/triage-template-how-to-diagnose-clustered-data-ontap-nfs-issues?language=en_US

shoong
4,372 Views

I just tried to run both commands and they both state they "are not recognized commands"

AlexDawson
4,368 Views

You need to run them from the Linux system - are you doing that?

shoong
4,366 Views

This is what I get when I run it against the new network interface that won't mount. When I run it against the other one, it just hangs.

storage-gateway-test.jpg

Public