greetings, i hope someone could help me with problem i have.
i am new to netapp, we have fas2020 active/active filler running 7.3.7 ontap
Due to infrastructure changes i need to implement vlan interfaces on vif's on both controllers.
I did edit rc file with this config on both controllers:
hostname xxxxvif create lacp agg0 -b ip e0a e0bvlan create agg0 111 116ifconfig agg0-111 192.168.111.250 netmask 255.255.255.0 mtusize 1500 partner agg1ifconfig agg0-116 192.168.116.10 netmask 255.255.255.0 mtusize 1500 partner agg1route add default 192.168.111.1 1routed on
hostname xxxxvif create lacp agg1 -b ip e0a e0bvlan create agg1 111 116ifconfig agg1-111 192.168.111.251 netmask 255.255.255.0 mtusize 1500 partner aggifconfig agg1-116 192.168.116.20 netmask 255.255.255.0 mtusize 1500 partner aggroute add default 192.168.111.1 1routed on
On the oposite site there is zyxel swith ,ports configured in trunk mode and vlan 111,116 are set up as tagged. I am able to ping both interfaces in each subnet according to configured IP addresses.
When i do cluster takeover, partner vif goes immediately down.
The older config wihtout vlan interfaces which we used to have was fine, cf takeover worked without any problem.
Any help appreciated.
See The Solution
your partner statement is incorrect, you need to add vlan.
ifconfig agg0-111 192.168.111.250 netmask 255.255.255.0 mtusize 1500 partner agg1-111
Also, you are on some VERY old hardware and code.. time to upgrade
View solution in original post