ONTAP Discussions

Highlighted

how to find if a volume has been re-sized - 7mode

hello,

i need to find out how much space has been added to a specific volume i have on a 7mode system [NetApp Release 8.1 7-Mode], i have downloaded the autosupport files with dates before and after the modification but i can't find any leads, i can only find the current space of the volume in a file called DF.txt, could someone please help ?

3 REPLIES 3
Highlighted

Re: how to find if a volume has been re-sized - 7mode

The size difference between the current space of the volume from the old autosupport log (prior the modification) and the new autosupport (after the modification) is the value of the space that was added.

Highlighted

Re: how to find if a volume has been re-sized - 7mode

In a lab I created a 1 gig volume. Then added 1 gig of space. The DF ouput showing the size increase from 996148kb to 1992296kb is below. The values are not exact because of metadata (overhead). I copied 755MB of files to the volume. We see used increase and the available go down from 1992132 to 1124480. The DF file you found should have the data your wanting. If your not seeing the value change you may need to look at an older Autosupport. The names are timestamp.

 

NetApp_SR_0-1583486922112.png

 

View solution in original post

Highlighted

Re: how to find if a volume has been re-sized - 7mode

Does that version of ONTAP have a command history ASUP section? It's been a while but if you check the daily management log, you can see if that was the case.

Check out the KB!
Knowledge Base
All Community Forums