netapp reset to factory dual controler

[RAB1983]

I have 1 netapp 2040-2  dual controler ok

I am formatting storage, in boot netapp enter CRTL C

Option 4

my doubts

I have to format the 2 controllers or just one? same time?

thanks

[HENRYPAN2]

Hi Ronaldo,

Does your FAS2040-2 is serving production data?

If you have to formatting the disk, you may wish to do it one controller at a time with cf enable to keep the app running at half the speed.

Not sure the reason you wish to formatting. Did you open a case with NetApp support?

Good luck

Henry

[GLENYU5820]

Hi Ronaldo,

The reset process should wipe out everything, then you can go through the setup to start from scratch.

Thanks

Glen

[HENRYPAN2]

Saluting Glen for such a better advice :>)

Cheers

HP

[aborzenkov · Accepted solution]

If you want to reinstall Data ONTAP, you need to do it on both controllers.

Отправлено с iPhone

30 окт. 2013 г., в 16:40, "ronaldo barros" <[email protected]<mailto:[email protected]>> написал(а):

<https://communities.netapp.com/index.jspa>

netapp reset to factory dual controler

created by ronaldo barros<https://communities.netapp.com/people/RAB1983> in Data ONTAP - View the full discussion<https://communities.netapp.com/message/119515#119515>

I have 1 netapp 2040-2 dual controler ok

I am formatting storage, in boot netapp enter CRTL C

Option 4

my doubts

I have to format the 2 controllers or just one? same time?

thanks

Reply to this message by replying to this email -or- go to the message on NetApp Community<https://communities.netapp.com/message/119515#119515>

Start a new discussion in Data ONTAP by email<mailto:discussions-community-products_and_solutions-data_ontap@communities.netapp.com> or at NetApp Community<https://communities.netapp.com/choose-container.jspa?contentType=1&containerType=14&container=2877>

[scottgelb]

You can also "halt -c factory" (7-Mode) from advanced mode... then destroy and zero any data aggregates after...sometimes can be quicker.  But option 4a will do it too.

[rdenyer001]

Anyone know if there is an cDOT  option similar  to this,

I have a pool  of FAS2240  systems which are used for reseller demos  and I have been looking fro an easy way to get them set back to "Factory Default".

Have been using the  reboot  Crtl - C  => option 4  , but  have to do that  on each controller.

Regards,

Richard