I am stumbling out of the blocks on the initial configuration of a FAS 2040 connected (SAS & ACP) to a single DS4243.
I power on and connect via serial cable. Initial research/documentation led me to believe a wizard would start after post and this is not the case. I am also concerned because the post states the SAS controller failed and there is no link light (perhaps a sign of larger problems).
I assume that I would configure the ethernet port to the direct right of the ACP connection (e0P) with an IP address for management. But when I navigate to "show devices" in the terminal session, I only see e0P and e0a thru e0d.
I could not find a clear setup guide through NetApp's documentation. If anyone can begin pointing me in the right direction, it would be appreciated...