ONTAP Hardware

UAT2 ports connected to Brocade switch are not showing WWPN

mip1
4,929 Views

Hello - Got a question about new NetApp we deployed. We connected NetApp to Brocade Fabric via onboard FC ports and UAT ports in additional card. Onboard ports connecting fine to Fabric and we are able to see NetApp WWPNs on Brocade ports but UAT are showing "In_Sync" and don't show NetApp WWPNs.

UAT ports mode has been changed to FC. There is no FC LIFs configured on NetApp yet.

Do we need to do anythihng different for UAT ports which I am missing?

6 REPLIES 6

SpindleNinja
4,894 Views

Did you do a reboot or takeover of each controller after you switched to FC on the UTAs? 

 

mip1
4,662 Views

Yes, reboot was done and ports are showing as fc with no pending Mode when ucadin show command is given.

SpindleNinja
4,611 Views

Just to confirm,  you have link lights on both ends, just no FLOGI from the physicals WWPNs on the UAT adaptors?   

 

I would try bouncing the port swtich side.     And maybe create a lif in the FCP SVM. 

cedric_renauld
4,548 Views

Hello, 

Can you give s a switchshow result command from the brocade ?

Pls.

mip1
4,526 Views

Hi,

Attached is the switch port status (switchshow) for two netapp controllers. I have already tried bringing switch port down and up. Also have tried setting port speed manually on the Netapp side.

 

cedric_renauld
4,511 Views

Hello, 

can you send us this command's result ?

system node hardware unified-connect show

and 

 

run * sysconfig -a 

 

Public