ONTAP 9.2 Simulator

[MARCUSBURROWS]

Hi all

has anyone come across a problem with the 9.2 simulator on ESX where you enter maintenance mode and the prompt doesn't return a response?  ie you can carry on typing as much as you like but the console doesn't actually accept the command.

I am trying to assign disks so this is a show-stopper.

Thank you for any help

Marcus

[SeanHatfield]

Thats an issue with the vidconsole in that version of the simulator.  Maintenance mode console output is going to the comconsole.  Two possible workarounds would be configuring/using the comconsole, or booting into ontap and doing the simulator disk management steps from the node shell & systemshell.  

[MARCUSBURROWS]

Thank you very much Sean.  I have also received some instructions regarding that, so if anyone else has similar issues:

1) Connect another VM to the simulator using a serial over network connection.    See: https://kb.vmware.com/s/article/2004954

2) Change the VLOADER setting as Sean has said:    setenv console comconsole

3) Connect from the other VM using Putty (or similar) on a COM port.  Default baud rate is 9600.

Regards

Marcus