Solved: Re: Connect to vfiler with ONTAPI via HTTP/HTTPS, err=10061

cat_towerbe · ‎2012-03-06

Hi all,

WARNING: I'm not a programmer.

I'm using zexplorer to try and troubleshoot a problem with a program I'd like to use, but I'm seeing something odd when trying to connect to vfilers.

I have an active/active pair running ONTAP 8.0.2P3.

I have several vfilers running on each controller.

On controller 1, I can use an HTTP connection to any and all of the vfilers and get an appropriate response.

On controller 2, If I use an HTTP connection, I can connect with vfiler0 (the base unit), but not if I try to connect to any of the vfilers on that controller. I get the following error message.

This is really odd because the physical filers are a cluster pair, built at the same time, running the same version of the OS, configured identically as far as I can tell, and the vfilers were built at the same time.

Any recommendations for figuring this one out?

Thanks in advance,

Brian

rle · ‎2012-03-06

Hi Brian -

Compare the HTTP options between the working vfilers and the non-working vfilers. Here is an example below.

toaster> vfiler run vfiler1 options http

===== vfiler1

httpd.access legacy

httpd.admin.access legacy

httpd.admin.enable on

httpd.admin.hostsequiv.enable off

httpd.admin.max_connections 512

httpd.admin.top-page.authentication on

httpd.autoindex.enable off

httpd.bypass_traverse_checking off

httpd.enable off

httpd.ipv6.enable off

httpd.log.format common

httpd.method.trace.enable off

httpd.rootdir XXX

I assume you have verified that the IP address are valid for the non-work vfilers by ping or rsh.

Regards,

- Rick -

View solution in original post

rle · ‎2012-03-06