Autosupport for C-Mode

[nachin]

I am new to clustered OnTap. I used to use autosupport to check system configurations of my 7-Mode controllers. The information is just rich and helpful.

However, system configurations are vServer-based in C-Mode controllers. How can I check the settings such as

network port show?

Any replication would be appreciated.

[mikkisse]

Hello!

You feel free to configure autosupport in C-Mode 🙂

http://community.netapp.com/fukiw75442/attachments/fukiw75442/autosupport-and-my-autosupport-articles-and-resources/11/1/AutoSupport+QuickStartGuide.p...

[AGUMADAVALLI]

use the "my autosupport" from now.netapp.com to browse to node or SVM or cluster specific details.

thank you,

AK G

[asulliva]

If you are getting a full AutoSupport from your nodes, I believe the data you want is in the cdb-net-port.xml and cdb-net-vifs.xml files.  If you're looking for LIF information, it's in the network-interface.xml file.

Note that AutoSupport is sent on a per-node basis, not cluster.  So each node will only report it's own data, and all of them together equates to the cluster.

Andrew