Microsoft Virtualization Discussions

Highlighted

Set-NaNetInterface -NoDdns not working

set-NaNetInterface don't set  parameter noddns on interface with PS v2.2 , just ignored.

Is someone experience the same?

11 REPLIES 11
Highlighted

Re: Set-NaNetInterface -NoDdns not working

Hi Francois, could you please elaborate more on your issue.

Highlighted

Re: Set-NaNetInterface -NoDdns not working

options dns.update.enable set to secure and the content of

/etc/rc, 

ifconfig vif1-281 `hostname`-vif1-281 netmask 255.255.255.0 broadcast 10.139.81.255 partner vif1-281 up

I would like add an alias on this interface by PS without this ip will register in dns.

PS>Set-NaNetInterface -InterfaceName vif1-281 -Alias 10.11.11.11 -NoDdns

Active configuration works fine

ifconfig vif1-281

vif1-281: flags=0xa4c863<UP,BROADCAST,RUNNING,MULTICAST> mtu 1500

        inet 10.139.81.13 netmask 0xffffff00 broadcast 10.139.81.255

        inet 10.11.11.11 netmask 0xff000000 broadcast 10.255.255.255 noddns

        partner vif1-281 (not in use)

But RC configuration is not created with no_ddns flag

/etc/rc

ifconfig vif1-281 alias 10.11.11.11 netmask 255.0.0.0 broadcast 10.255.255.255 up 

Highlighted

Re: Set-NaNetInterface -NoDdns not working

Seems I'm litle bit alone on this thread, anyway I would be very happy if somebody can make a test with Set-NaNetInterface powershell command and confirm that /etc/rc ifconfig line is successfully modified?

I tested on  7.3.7, 8.1.1, 8.1.2 with same problem

francois

Highlighted

Re: Set-NaNetInterface -NoDdns not working

Hi Francios, 

  I tried this with toolkit version 2.2 and can verify the /etc/rc does NOT get the no_ddns switch added.

This may be an oversight in the Set-NaInterface cmdlet design.

Highlighted

Re: Set-NaNetInterface -NoDdns not working

Hi Vinith,

Do you know how this oversight can be fixed. NGS support case? probably not

francois

Highlighted

Re: Set-NaNetInterface -NoDdns not working

Hi Francois, I would check it up and get back soon.

Highlighted

Re: Set-NaNetInterface -NoDdns not working

Could you please let us know what version of the toolkit you are using and what version of Data ONTAP you are running it against ?

Highlighted

Re: Set-NaNetInterface -NoDdns not working

The version is that embeded in WFA 2.0 so toolkit version 2.2 and I tested on 7.3.7, 8.1.1, 8.1.2 with the same issue.

Highlighted

Re: Set-NaNetInterface -NoDdns not working

Hi Francois thanks for bringing this to our attention, we’ll work on it to get it fixed in the next release of the toolkit.

Try the NEW Support Site!
NetApp Support Site
Forums