I thought it was due to be out by now. Just checked
But only lists 1.2R1.
Will post this thread to the NetApp SMVI PM and get him to say what is happening.
The SMVI PM is a she :-). Now that's cleared up, SMVI 2.0's official FCS date is end of October, but keep your fingers crossed, I'm hoping we'll beat that date. It is worth waiting for!
Hope this will be on next few days, cannot wait more...
Waiting for Snapshot's fullnaming control for use with NDMP backup on BackupExec. I Wouldn't begin writing backup scripts with SV-SMVI to get snapshots names as the new SMVI version will fix this.
Is there a way to get some SMVI documentation? I am getting error messages on RestoreAgent.
Do we have to install Remoteagent on the destination VM, or can it be installed on any admin workstation or on the SMVI server?
Below is the message i get when starting Restore Agent console from my workstation :
"No access permissions present for guest with BIOS ID : xxxxxxxxxx-xxxxxxxxxxxxx-xxxxxxxxxx". It starts after canceling the dialog box.
When I install it on the destination VM (the one that need file restore), the above message did'nt appear when starting Remoteagent, but when i try to mount a backup i get the following error message :
"Could not find SCSI disk device Port  - Target - Bus  - Lun "
Some considerations :
- Just to notice that my VMware storage Netapp setup is based on NFS. No iSCSI datastore were used. So does Remoteagent support VMs on NFS storage?
- For security reasons I have setup IP restrictions on the filer. Should the Restoreagent needs connecting directely to the filer or does it communicate only with the SMVI server or VCserver ?
Thks for help