FAS 3220 and DS4243 cabling

[SagarDH]

Hi,

I am new to Netapp and storage technologies.

I have received Netapp FAS 3220 single controller and DS4243. I have done cabling and attached cabling diagram. Please let me know is that correct cabling.

Thanks,

[NAYABSK]

Hey Sagar, 

I didn't find any attachment here, May be you missed it out. Please find the default cabling diagram to connect disk shelf's to netapp controller.

Thanks,

Nayab

[SagarDH]

Thanks a lot for diagram. I have attached my cabling. Please verify and it going to production and It has single controller.

Thanks,

Vidya Sagar

[NAYABSK]

Hey Sagar, 

That's perfect man , Cool that you have closed the SAS loop as well 🙂  Your cabling right and is as per the Netapp Best practices 🙂

In future if you expand your environment and have doubts regarding cabling u can always run NETAPP CONFIG ADVISOR ( Can be installed on Windows Machine ) which checks the hardware status as well as the cabling in your environment.

Config Advisor can be downloaded from mysupport.netapp.com --> Tools --> Utility Toolchest 

Thanks,

Nayab

[SagarDH]

Hi Nayab,

Thanks a lot for tool just downloaded and installed. ACP cabling Passed and sas Cabling failed. Attached the error.

Thanks

[NAYABSK]

Hey Sagar, 

The key rule to remember is "Circle to Square".  All cables should go from a Circle port to a square port.

Top Controller (A) Circle port connects to Shelf 1 Top (A) module Square port

Bottom Controller (B) Circle port connects to Shelf 1 Bottom (B) Square port

Shelf 1 Top (A) module circle port connects to Bottom Controller (B) Square port

Shelf 1 Bottom (B) module circle port connects to Top Controller (A) Square port

As i didn't notice if it is circle or square port Can you cross check based on if every CIRCLE TO SQUARE ?

Thanks,

Nayab

[SagarDH]

Hi Nayab,

I have only one controller and attached my cabling diagram. after this connection i am not seeing any issues in config advisor. Still I want to confirm my cabling is good.

Thanks

[NAYABSK · Accepted solution]

Hey Sagar, 

Your cabling is good and also good to know config advisor showing no errors 🙂 . Please do remember as you have only one controller your setup will be a single point of failure ( As it is a standalone controller ) myself representing NetApp highly recommend using HA-Pair.

Thanks,

Nayab

**** If my reply helped to solve your issue, please help to mark it as answer to help others ****

[SagarDH]

Hi Nayab,

Yes we should have to have dual controller. I will plan in future budget. Thanks a lot for your setup.