ONTAP Discussions

Hot replacing of ESH4 ?


Hello guys,

I have two filers with the following configuration:
Data ONTAP Release 7.3.3:
System Storage Configuration: Multi-Path HA
System ACP Connectivity: Full Connectivity


Both filers report the following  error:


ses.status.temperatureWarning:warning]: DS14-Mk4-FC shelf 5 on channel 2a temperature warning for Temperature sensor 3: not installed or failed.
Current temperature: <N/A> C (<N/A> F). This module is on the rear side of the shelf, at the bottom center, on shelf module B


monitor.shelf.fault:CRITICAL]: Fault reported on disk storage shelf attached to channel 2a. Please check fans, power supplies, disks, and temperature sensors.


monitor.globalStatus.critical:CRITICAL]: Disk shelf fault.


Actually I need to replace the shelf module B.


1/ Normally as I have a multipath HA config it can be done without disruption. (is it true?)

2/ According to doc, I should disable adapter 2a remove ESH module B , replace it and enable adapter ( is it ok)

3/ If I have to disable the adapter 2a on which filer should it be done, how can be sure on which ctrl should I run the command to disable adapter?




NetApp on Discord Image

We're on Discord, are you?

Live Chat, Watch Parties, and More!

Explore Banner

Meet Explore, NetApp’s digital sales platform

Engage digitally throughout the sales process, from product discovery to configuration, and handle all your post-purchase needs.