Migration aggregate and volumes to other NetApp

[Bronkz]

Hello,

I have a NetApp with 7-mode 8.2.1 and I need to migrate aggregate on vfiler and all volumes with this aggregate to other NetApp. Is it possible to copy all non-distruptive? If no, Could You please write other solution step by step ?

[NAYABSK]

Hi,

May i know if you are going to migrate with HA-Pair or across to other controller in a different HA-pair ?

If this is within a HA-Pair then follow the below procedure 

Now let us assume i have two controller filerA & filerB and i am moving aggregate from A to B 

Change options (both controllers):

options disk.auto_assign off

options autosupport.enable off

options httpd.enable.access on (for disk refresh)

Verify Volume Status:

vol status –s

Verify Disks

filer> disk show <disks>

Offline Volumes

filera> vol offline

Offline Aggregates

filera> aggr offline <aggr>

filera> aggr offline <aggr>

Note current disk ownership/IDs:

Removing ownership of the disks:

filera> priv set advanced

filera*> disk remove_ownership <disks>

Verify Disk Ownership (not owned):

filera> disk show –n

filera> options disk.auto_assign on

On the controller filerB

Change disk auto assign:

options disk.auto_assign off

Verify Disk Ownership (not owned):

filerb> disk show –n

Take ownership of the disks

priv set advanced

filerb*> disk assign 0b.22 0b.23 –s <filerb serial#>

Verify Disk Ownership (all visible disks)

filerb> disk show –v

Verify disks correctly assigned

filerb> aggr status –r / aggr status –s

Online Aggregate

filerb> aggr online <disks>

filerb> aggr online <disks>

Change options back:

options disk.auto_assign on

options autosupport.enable on

options httpd.enable.access off (for disk refresh)

Thanks,

Nayab

***If my reply helped to solve the issue, please help to mark it as solution so that it would be helpful to other with same issue****

[OmSrivastava]

Hi, 

I want to move just few volumes to the other controller (HA Pair ) having version 8.2.4 .  What would be the requirements for volumes (offline/online/flexclone etc. ) . Could you please help me with both ways CLI and DFM .

Many thanks in Advance !!!

[OmSrivastava]

Please reply with full procedure.

Thanks!!

[Bronkz]

Hello,

NetApps are out of HA-pair.

[NAYABSK · Accepted solution]

So i should understand that you have same or more space as same as the source controller at the destination controller  ??

In that case i would suggest a copy method or best option to go with snapmirror 

1) Create as same agrregate structure in the destination as same as source ( Including volumes )

2) Create a snapmirror relation and initiate the transfer........

Thanks

Nayab

[Bronkz]

Yes, I have a free space on destination. Ok I will try to use Snapmirror. Thank you for understanding.

[NAYABSK]

Sure, Let me know if you have any doubts further 

Thanks,

Nayab