Full error message :"SnapMirror subsystem is not fully operational yet. Wait a few minutes and try the command again."
when I try to migrate a volume from 7-mode to cDOT, either by 7MTT or by snapmirror on console.
Snapmirror license OK, peering OK, ports open.
90456 Error Failed to create the SnapMirror relationship for the following clustered Data ONTAP volumes.
Target SVM Volume Error Code Error Detailsnetapp11(netapp11):netapp-archiv01 voltest2 13001 SnapMirror subsystem is not fully operational yet. Wait a few minutes and try the command again.
Anyone had this error before?
See The Solution
That was the external link so i'm not sure why you can't access it but here is what the KB says:
Snapmirror create fails with the error:
SnapMirror subsystem is not fully operational yet. Wait a few minutes and try the command again. or...
Error: command failed: Failed to compute the Vserver identification from this content.
Given you mentioned you recently moved the hardware between DC's the issue might have occurred when it was added to the cluster in which case a node reboot should resolve it.
View solution in original post
Have you seen this KB?
"KB article Not found. Please check the URL or KB number and try again."
Rebooted both nodes of the destination cluster and now it works!
Thx a lot!
Thank you for writing to NetApp community. Could post the 7MTT logs here ?
When the error says the subsystem is not ready. I would like to know was the cluster setup already ? or in progress ? or in initialization state ?
Check the cluster health to know if it is healthy
NetApp> Cluster show
I have to admit that the cluster was set up, then moved to a different data center location, but we dont have the ISLs up yet
(resulting in "mirror degraded" aggregates).
I suppose that this could be the problem, but am not sure.
Live Chat, Watch Parties, and More!
Engage digitally throughout the sales process, from product discovery to conﬁguration, and handle all your post-purchase needs.