Snapmirror throttle changes after baseline starts

[ACHOU_SIMG]

Hi,

Environment: clustered ontap 8.3RC2

I am setting up snapmirror from my 7 mode filer to clustered ontap. I had throttle set to a low value initially and started the baseline transfer. Before the baseline finishes, I realize I should have set to a much higher value so I set it to a much higher value. It does not seeem to be much faster though. Does changing throttle value after starting initial transfer take effect immediately?

Thanks,

[ekashpureff]

Achou -

Per another recent post here on the community -

No, the new setting won't take effect untill the next transfer...

I hope this response has been helpful to you.

At your service,

Eugene E. Kashpureff, Sr.
Independent NetApp Consultant http://www.linkedin.com/in/eugenekashpureff
Senior NetApp Instructor, IT Learning Solutions http://sg.itls.asia/netapp
(P.S. I appreciate 'kudos' on any helpful posts.)

[Fränk · Accepted solution]

We do an abort of Snapmirror transfer during Baseline transfer and initialize again. It continues using the new throttle with last checkpoint.

[ACHOU_SIMG]

Yes. I had to do the same to tell it to pick up the new settings.

Thank you!