I have a FAS6080 with ontap 7.2.6 on it. The filer have 4 aggr. Three of them have SATA disks and one have FC disks. In the moment the volumes of one vfiler are on different disks and I have to write a plan them.
My problem is, that the root volume of the vfiler is on a FC-aggr and I have to move it SATA-aggr.
I also don't want to create a new topic, because my situation is absolutely the same. I need to move root vfiler volume from SAS disks to SATA.
I have FAS3240 and NetApp Release 8.2.4P2 7-Mode
There is a dead link above and a procedure of motion with recreation of a vfiler. But I want to know, is it possible not to destroy, but just stop a vfiler; use "vol move" to move root vfiler volume and start vfiler again then? (vfiler is used for NFS-shares)
Do I have to stop the vfiler?
IF I do stop the vfiler, does that suspend all NFS sharing?
Don't want to create a new topic, because my situation is absolutely the same. I need to move root vfiler volume from SAS disks to SATA.
I have FAS3240 and NetApp Release 8.2.2P1 7-Mode
There is a dead link above and a procedure of motion with recreation of a vfiler. But I want to know, is it possible not to destroy, but just stop a vfiler; use "vol move" to move root vfiler volume and start vfiler again then? (vfiler is used for CIFS-shares)
From our Insight Conference Labs.. an example of how to move a vFiler root volume. It requires that you enable the network after... a little bit of a shell game... I recommend trying it in the simulator or with a test vFiler first, then when comfortable run it on your vFiler.
This lab will move the vfiler root volume for fas6280a_vfiler1 running on the fas3270 node. The vfiler must be stopped, destroyed and recreated using the same root volume name (the new root must be renamed to the old root name). This is quite different from moving a vfiler0 root volume using “vol options volname root”.
You can rename the volume with “vol rename old new” anytime, however to acdtually move the root volume requires that we destroy and recreate the vFiler using the same name of the root volume before/after the move to another aggregate.
Volume Data Motion (when supported by NAS volumes) was introduced in Data ONTAP 8.0.1. When supported on NAS it will eliminate the need for this lab. Volume Data Motion for NAS works in 8.0.1 but is only supported for SAN volumes and availability of the volume is not guaranteed for NAS.
The procedure below will move the fas6280a_vfiler1 root volume from aggr1 to aggr_root
Create new root vol, restrict it, and vol copy the existing root to the newroot
NOTE: the ns1 interface will not be configured and needs to be configured. You can ifconfig the interface, or use the “setup -e”, but setup -e will wack some files since the setup command updates hosts.equiv, exports, resolv.conf, etc. These can be restored from the .bak versions copied at setup time or from snapshots. You will need to fix the rc file in a production environment (.105 will be left over from the prior lab…multistore doesn’t always clean up rc as expected).
fas3270> vfiler status -a # not the interface is unconfigured
fas3270> ifconfig ns1 alias 192.168.150.103 # might not be an alias in your case.
alternatively (wacks some files) - fas3270> vfiler run fas6280a_vfiler1 setup -e ns1:192.168.150.103:255.255.255.0 (don't use setup - use ifconfig)
fas3270> vfiler status -a # not the interface is configured