ONTAP Discussions

snapmirror source volume size (resize) - will the destination vol resize too?

maskajan09
3,805 Views

Hello

I found some post here about this but it is still not clear to me. ONTAP 9.5P3. SVM snapmirror DP.

1) if I resize the source volume is it going the destination vol resize accordingly? What must be set to make it work?

2) is there any special procedure how to resize snapmirrored vol to resize the destination accordingly?

3) I cannot find such an obvious task described in any doc. Is there any doc that describes this?

 

Thank you

5 REPLIES 5

mjdalton1
3,787 Views

Volume autosize can be your friend. This needs to be enabled on both sides if you use it.

 

https://docs.netapp.com/ontap-9/index.jsp?topic=%2Fcom.netapp.doc.dot-cm-vsmg%2FGUID-ECE453FE-D158-4BDA-9851-6B8780474E11.html

 

maskajan09
3,781 Views

The autosize-mode on dest is grow_shrink and on source is off. So I would say that it is enough to have it on dest only but I suspect that it must be also on source, right? Why?

mjdalton1
3,743 Views

I was stating both sides for simplicity. Your configuration should be OK to add storage to the source and allow the destination to autogrow.

SpindleNinja
3,786 Views

Give this a read through: https://kb.netapp.com/app/answers/answer_view/a_id/1073852/loc/en_US  


And just to verify,  you mean Snapmirror DP relationship.  not SVM-dR or XDP? 

maskajan09
3,696 Views

Well it is SVMDR relationship. So it is not that easy. But there is a command int KB for this. Hopefuly it will work...

Public