Yeahh , i did try the following commands & below are the outputs
1. I checked the disk.autoassign option , which was ON
netapp> options disk.auto assign
Setting invalid option disk.auto failed.
disk.auto_assign on
2.I tried to switch off the option as oer below command
netapp> options disk.auto_assign off
netapp> options disk.auto_assign
disk.auto_assign off
3.then I entered disk ? & below is the output
netapp> disk ?
usage: disk <options>
Options are:
fail [-i] [-f] <disk_name> - fail a file system disk
remove [-w] <disk_name> - remove a spare disk
swap - prepare (quiet) bus for swap
unswap - undo disk swap and resume service
scrub { start | stop } - start or stop disk scrubbing
replace {start [-f] [-m] <disk_name> <spare_disk_name>} | {stop <disk_name>} - replace a file system disk with a spare disk or stop replacing
simpull <disk_name1> [<disk_name2> [<disk_name3> ... ]] - simulate one or more disk pulls
simpush [<sim_disk_path_name1> [<sim_disk_path_name2> [<sim_disk_path_name3> ...]] | -l] - simulate one or more disk pushes or list available disks to push
zero spares - Zero all spare disks
checksum {<disk_name> | all} [-c block | zoned]
sanitize { start | abort | status | release } - sanitize one or more disks
maint { start | abort | status | list} - run maintenance tests on one or more disks
I also tried storage disk assign
storage disk assign
storage: unrecognized command "disk"
usage: storage <subcommand>
subcommands are:
alias [ <alias> { <electrical_name> | <wwn> } ]
disable adapter <name>
download shelf {channel | shelf} download shelf -R to revert firmware to the version shipped with the current Data ONTAP version
download acp [<adapter_name>.<shelf_id>.<module_number>] download acp -R to revert firmware to the version shipped with the current Data ONTAP version
enable adapter <name>
help <sub_command>
rename switch <oldname> <newname>
release { mc | tape } <name>
show adapter [ -a ] [ <name> ]
show disk [ -a | -x | -p | -T ] [ <name> ]
show expander [ -a ] [ <expander-name> ]
show fabric
show fault [ -a ] [ -v ] [ <shelf-name> ]
show hub [ -a ] [ -e ] [ <hub-name> ]
show initiators [-a]
show mc [ <name> ]
show port [ <name> ]
show shelf [ -a ] [ <shelf-name> ]
show switch [ <name> ]
show tape [ <name> ]
show tape supported [ -v ]
show acp [ -a ]
stats tape <name>
stats tape zero <name>
unalias { <alias> | -a | -m | -t }
power_cycle shelf -h
power_cycle shelf start [-f] -c <channel_name> [-s <shelf_id>]
power_cycle shelf completed
netapp>
I cannot find the "assign command" here , please let me know what else should i try to get this option working ?
