VSC 5.0 shows netapps only once afterwards timeouts and wrong counts

[CSEIZMAIR]

Hi all,

we have Vcenter 5.5 (appliance) and VSC 5.0 installed on a Windows 2k8 system. Everything looked good after the install. I can see all 4 NetApp heads. But after browsing around in Vcenter none of the NetApp pages or counter updates. Or if it does it shows wrong counts. Instead of 4 heads it shows 17.

If I wait over night it recovers but starts to act up again after a few clicks. The same happens when I restart the VSC service.

I attached a few pictures of what it looks like. I currently looking at TCP dumps and logs but so far it looks all normal. Does anyone else experience a similar issue?

Thanks

[CSEIZMAIR · Accepted solution]

OK it looks like it was the same problem with SSLv3 instead of TLSv1 mentioned here: https://communities.netapp.com/message/131244#131244

As mentioned by JBROADWAY I forced the SMVI wrapper to use TLSv1 only and that seems to have helped.