hi guys
I am working on this FAS2020 using a console cable attached to my computer. Cool I run commands and everything.
Now I read that BMC interface will let me configure autosupport and send email in case my FAS2020 fails....but I was thinking I had the option to manage my FAS2020 like I did with the console cable running commands and so on...but I dont see this, I am accessing my BMC with ssh and no commands available like using console cable.
so my question is BMC capable of running commands like direct attached console cable or is it just for autosupport and low level commands
bmc shell -> help
exit Exit shell (or press ^D)
bmc config Display BMC configuration
bmc config autoneg [enabled|disabled] Enable/Disable ethernet port auto negotiation
bmc config dhcp [on|off] Set BMC dhcp
bmc config duplex [full|half] Set ethernet port duplex mode
bmc config gateway [gateway] Set BMC IP Gateway
bmc config ipaddr [ip-address] Set BMC IP Address
bmc config netmask [netmask] Set BMC IP Netmask
bmc config speed [10|100] Set ethernet port speed at 10M or 100M
bmc show Show BMC version and system information
echo [string] Print [string] to the console
events all Print all system events
events info Print SEL(system event log) information
events latest [N] Print N latest system events
events oldest [N] Print N oldest system events
events search [attr=N] Search for events by attribute/value pair
events show [N] Print event N
fru show Show chassis FRU data
priv Show current privilege level
priv set Return to admin privilege
priv set admin Enter admin privilege
priv set advanced Enter advanced privilege
sensors search [attr=N] Display a sensor by attribute
sensors show Display current state of sensors
system console Return to the system console
system core Dump system core
system log Show the system console history
system power cycle Power cycle controller
system power off Power off controller
system power on Power on controller
system power status Display Power Status
system show Show system information
thanks
