ONTAP Discussions

ETC$ and C$ empty

tchuise92
16,867 Views

hii excuse me i just started data ontap 7-mode and i have a problem when i try to access in my c$ and my etc$ from my domain controller it is empty i first thought that all the folders were hidden but i check the capacity of the folder and it is marked 0 byte thank you in advance for your help

11 REPLIES 11

JGPSHNTAP
16,828 Views

You're vol0 security is probably unix

 

type 

qtree status vol0

 

 

tchuise92
16,826 Views

i just checked and it is ntfs

JGPSHNTAP
16,818 Views

Then you have permissions.. What's the share level permissions and then you need to check NTFS rights

tchuise92
16,813 Views

about the permission i have the full control(rwx) on the share o both C$ et etc$

rwelshman
16,753 Views

Can you check the CIFS shares on the filer to see where c$ and etc$ are pointing?

tchuise92
16,742 Views

i don t know where they are pointing but to reach the C$ its / and the etc it is/etc like i the image below

rwelshman
16,722 Views

Ok, it should be pointing to vol0, can you do a "vol status vol0" "df -g vol0" "qtree status vol0"?

tchuise92
16,711 Views

i dont understand when you say it should be pointing to vol0 how can i make it point to vol0?? i did the 3 commands you asked me to do what is it for??really thank you for your understanding 

rwelshman
16,693 Views

You might want to increase the size of vol0, this is where the Data OnTap operating system files are kept. The C$ and etc$ shares will open to directories on this volume.

 

The used space looks really low, what version of Data OnTap are you running?

tchuise92
15,326 Views

hi i increased the space available in the vol0 but it is still an empty folder i am using data ontap 8.2.3 7-mode the simulator 

tchuise92
15,323 Views

hi i increased the Vol0 space an it is still an empty folder  i am using data ontap 8.2.3 7-mode simulator 

Public